Mechanical Joint 45 Bends - Full Body, AWWA C110, DI (in)

on . Posted in Ductile Iron Flanged Fitting Datasheets

  • *  These fittings are not included in AWWA C110/A21.10
  • For flange dimensions see Flange - ANSI Class 125, C110, DI
  • AWWA C110/A21.10 - Ductile-Iron and Gray-Iron Fittings (3" to 48")
  • ASME B16.1 - Gray Iron Pipe Flanges and Flanged Fittings: Classes 25, 125, and 250 (Flange surfaces shall be faced and drilled in accordance with ANSI Class 125)
  • AWWA C104/A21.4 - Standard for Cement-Mortar Lining for Ductile-Iron Pipe and Fittings for Water
  • AWWA C111/A21.11 - Rubber-Gasket Joints for Ductile-Iron Pressure Pipe and Fittings
  • Ductile iron mechanical joint fittings 3" through 24" shall be rated for 350 PSI working pressure.
  • Flanged ductile iron fittings in 24 inch and smaller sizes may be rated for 350 psi with the use of special gaskets.
  • MJ - mechanical joint
  • PE - plain end
  • FLG - flange

mj bend 45 1 dimechanical joint by mechanical joint

mj bend 45 3 dimechanical joint by plain end

mj bend 45 2 dimechanical joint by flanged

 

 

 

 

 

 

 

 

 

 

Pipe SizeDimension (in)Approx. Weight (lb)
RCDMJ x MJMJ x PEMJ x FLG
*  2 1.96 1.8 - 16 - -
3 3.62 3.0 11.0 30 - -
4 4.81 4.0 12.0 53 48 45
6 7.25 5.0 13.0 77 60 69
8 8.44 5.5 13.5 110 107 111
10 10.88 6.5 14.5 172 168 167
12 13.25 7.5 15.5 222 215 218
14 12.06 7.5 15.5 311 - -
16 13.25 8.0 16.0 364 360 360
18 14.50 8.5 16.5 531 430 455
20 16.88 9.5 17.5 655 543 664
24 18.12 11.0 19.0 865 1099 825
30 27.75 15.0 23.0 1447 - 1510
36 35.00 18.0 26.0 2435 - 1930
42 42.25 21.0 - 2955 - -
48 49.50 24.0 - 4080 - -